I have WINSET.EXE running from KIX32.EXE setting the path. The only problem is it sets the path for the Master UET and not the UET copied when the KIX32 VM is created. However, after it runs you can run a path from the DOS Prompt and see the changes. I could not get the KIX32 SHELL to work since it apparently tries to execute an INTERNAL command. RUN works nicely though! To add a W:. to the current path I did the following:

RUN "WINSET path=%path%"+"W:."

Hope this is some help!

Jack
jarnold@ipscardsolutions.com